Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Pump & Power Steering Pressure Hose
    GM65356Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pressure hose (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the power steering pressure hose (2) to the power steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  3. Install the power steering pressure hose (2) to the power steering pump (1).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  4. Install the power steering pump pulley. Refer to Power Steering Pulley Replacement .
  5. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About Mike's Workshop Manuals