Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo Extended, 6.6 6 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L (LMM) - Introduction (2 Of 2) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: Identifying ECT Sensor
    GM1861925Courtesy of GENERAL MOTORS CORP.
  1. If installing the old sensor(s), coat the threads with sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent.
    2. NOTE: Refer to Fastener Notice .
  2. Install the appropriate ECT sensor(s) (1).

    Tighten:  Tighten the sensor(s) to 20 N.m (15 lb ft).

    3. Fig 2: Identifying ECT Sensor
    GM1861923Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector(s) (1) to the appropriate ECT sensor(s).
  4. Fill the cooling system, if necessary. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (Vac N Fill) .
  5. Install the intake manifold tube. Refer to Intake Manifold Tube Replacement (LLY, LBZ) or Intake Manifold Tube Replacement (LMM) .
scientia non olet · About Mike's Workshop Manuals