Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo Extended, 6.6 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 819 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Wheel Speed Sensor Replacement (2WD) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug the WSS bore to prevent debris from falling into the hub.
  2. Using a wire brush or equivalent, clean the WSS mounting surface on the hub to remove any rust or corrosion.
  3. Apply a thin layer of wheel bearing lubricant, GM P/N 01051344 to the hub surface and the sensor O-ring prior to sensor installation.
    4. Fig 1: Removing Wheel Speed Sensor From Hub/Bearing Assembly (2WD)
    GM887991Courtesy of GENERAL MOTORS CORP.
  4. Install the WSS (5) into the hub/bearing assembly (4) shown on the 2500/3500 Series. Ensure that the sensor is seated flat against the hub.
    5. Fig 2: View Of Wheel Speed Sensor Mounting Bolt
    GM924317Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the WSS mounting bolt.

    Tighten:  Tighten the WSS mounting bolt to 18 N.m (13 lb ft).

    6. Fig 3: View Of Wheel Speed Sensor Cable And Connectors
    GM913362Courtesy of GENERAL MOTORS CORP.
  6. Install the WSS cable mounting clip to the knuckle.
  7. Install the WSS cable mounting clip to the upper control arm.
  8. Install the WSS cable mounting clip to the frame attachment point.
  9. Connect the WSS cable electrical connector.
    10. Fig 4: Front Brake & Hub Assembly (2WD)
    GM885802Courtesy of GENERAL MOTORS CORP.
  10. Install the brake rotor (2) shown on the 1500 Series. Refer to Brake Rotor Replacement - Front in Disc Brakes.
  11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  12. Perform the vehicle diagnostic system check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About Mike's Workshop Manuals