Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo Extended, 6.6 2 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341 >> DTC P0128 >> Circuit/System Testing

Circuit/System Testing

  1. Verify the proper heat range and for a stuck open thermostat. Refer to Thermostat Diagnosis .
  2. Ignition OFF, disconnect the harness connector at the ECT sensor.
  3. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the control module.
  4. Ignition ON, verify the scan tool ECT parameter is less than -39°C (-40°F).
    • If greater than the specified range, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the control module.
  5. Install a 3A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT parameter is greater than 149°C (300°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the control module.
  6. If all circuits test normal, test or replace the ECT sensor.
scientia non olet · About Mike's Workshop Manuals