Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander LT, 3.9 1 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.9L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Replace the O-ring if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:   Tighten the nuts to 10 Nm (89 lb in).

    4. Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  4. Connect the CMP sensor electrical connector.
  5. Install power steering pump. Refer to POWER STEERING PUMP REPLACEMENT .
scientia non olet · About Mike's Workshop Manuals