Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander LT, 3.9 1 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.9L - Introduction (2 Of 2) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Install the air cleaner.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Locating Air Cleaner Bolts
    GM1404635Courtesy of GENERAL MOTORS CORP.
  2. Install the air cleaner bolts.

    Tighten:   Tighten the nuts to 10 Nm (89 in ft).

  3. Install the PCM and the wiring harness to the air cleaner.
  4. Install the air cleaner side cover and element. Refer to Air Cleaner Element Replacement .
    5. Fig 2: Identifying Air Cleaner Upper Cover & Bolts
    GM1404634Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner upper cover and the upper cover bolts.

    Tighten:   Tighten the nuts to 4 Nm (35 in ft).

  6. Install left front sheet metal diagonal brace. Refer to BRACE REPLACEMENT - SHEET METAL DIAGONAL .
  7. Install the coolant reservoir. Refer to COOLANT RECOVERY RESERVOIR REPLACEMENT .
  8. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
scientia non olet · About Mike's Workshop Manuals