Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing ECT Sensor
    GM1586322Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
  1. Drain the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM (STATIC FILL) .
  2. Drain the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM (STATIC FILL) .
  3. Remove the intake manifold cover, if necessary. Refer to INTAKE MANIFOLD COVER REPLACEMENT .
  4. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
  5. Remove the ECT sensor.
scientia non olet · About Mike's Workshop Manuals