Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Automatic Transaxle - Introduction & Repair Instructions) >> Repair Instructions >> Thermo Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Thermo Element Plate
    GM164816Courtesy of GENERAL MOTORS CORP.
  1. Use the J 34094-A  to set the middle thermo pin (123).
  2. Install the new thermo element plate (122).
  3. Install the pin (120) and the washer.
  4. Use the J 34094-A  to set the height of the pin and the washer furthest from the accumulator.
  5. Use the J 34094-A  to set the height of the second pin (120) and the washer.
    6. Fig 2: View Of Thermo Element & Plate
    GM164817Courtesy of GENERAL MOTORS CORP.
  6. Install the thermo element (121) between the two pins (120). The V in the thermo element (121) must contact the thermo element plate (122).
  7. Install the oil pan. Refer to Oil Pan Replacement .
  8. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals