Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

    Fig 1: View Of Ignition Lock Cylinder Case, Ignition Switch, Retaining Screws & Key Alarm Connector
    GM324871Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).
  3. Connect the theft deterrent control module connector.
  4. Connect the fused jumper assembly connector.
    Fig 2: View of Fused Jumper Assembly Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  5. Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
    Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About Mike's Workshop Manuals