Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0562 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the voltage at the battery terminals and compare it with the Ignition 1 Signal parameter in the ECM data list. Verify that battery and ignition 1 signal readings do not differ more than 1.0 volt.
    • If greater than 1.0 volt, test the ignition 1 ground circuits of the ECM for high resistance or replace the ECM.
  2. Go to Charging System Test .
scientia non olet · About Mike's Workshop Manuals