Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Engine Control System - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing The MAP Sensor And Bracket
    GM1614650Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor seal into the upper intake manifold.
  2. Install the MAP sensor and bracket.
    NOTE: Refer to Fastener Notice .
  3. Install the upper intake manifold bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Connecting The MAP Sensor Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  4. If required, install the spark plug wire clip to the intake manifold bracket.
  5. Connect the MAP sensor electrical connector.
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About Mike's Workshop Manuals