Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the fuel tank assembly. Refer to Fuel Tank Replacement .
    3. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel tank pressure sensor electrical connector.
  4. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
scientia non olet · About Mike's Workshop Manuals