Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Control System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug And Sparkplug Seat
    GM14824Courtesy of GENERAL MOTORS CORP.
  1. Correctly position the spark plug washer.
  2. Inspect the spark plug gap. Adjust the gap as needed.

    Specification:  Spark plug gap: 1.016 mm (0.040 in).

  3. Hand start the spark plug in the corresponding cylinder.
    NOTE: Refer to Fastener Notice .
  4. Tighten the spark plug.

    Tighten:  Tighten the plug to 15 N.m (11 lb ft).

  5. Install the spark plug wire. Refer to Spark Plug Wire Replacement .
scientia non olet · About Mike's Workshop Manuals