Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Control System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Do not use the fuel injector O-ring seals again. Install NEW fuel injector O-ring seals during assembly.
    Fig 1: Installing The NEW Fuel Injector O-Ring Seals
    GM1411907Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the NEW O-ring seals with clean engine oil.
  2. Install the NEW fuel injector O-ring seals (532, 534) onto the injector, as required.
  3. Install the fuel injector (533), as required
  4. Install the fuel injector retaining clip (521), as required.
  5. Install the fuel rail. Refer to Fuel Rail Assembly Replacement .
scientia non olet · About Mike's Workshop Manuals