Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Control System - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning The APP Sensor Assembly To The Vehicle
    GM1618780Courtesy of GENERAL MOTORS CORP.
  1. Position the APP sensor assembly to the vehicle.
    NOTE: Refer to Fastener Notice .
  2. Install the APP sensor assembly bolts.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    3. Fig 2: Connecting APP Sensor Electrical Connector
    GM1618756Courtesy of GENERAL MOTORS CORP.
  3. Connect APP sensor electrical connector (1).
  4. Install the left I/P sound insulator. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About Mike's Workshop Manuals