Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Drive Cable Replacement - Horizontal >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Seat Components
    GM817977Courtesy of GENERAL MOTORS CORP.
  1. Insert the end of one cable (4) into the drive screw (3).
  2. Bend the cable and insert the other end into the motor (1).
    3. IMPORTANT: Examine all 4 drive cables to ensure that the cables are straight.
  3. Connect the electrical connector to the seat wire harness and test the seat for proper operation.
  4. Examine the horizontal drive cables for synchronization. Refer to Seat Adjuster Phase Adjustment - Power .
    5. Fig 2: View Of Front Seat Bolts
    GM305124Courtesy of GENERAL MOTORS CORP.
  5. Tip the seat forward and engage the seat hook attachments to the floor plan.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the bolts that secure the adjuster to the floor plan.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

scientia non olet · About Mike's Workshop Manuals