Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing EGR Valve
    GM1239053Courtesy of GENERAL MOTORS CORP.
  1. Install a new EGR valve gasket.
  2. Install the EGR valve.
    3. NOTE: Refer to Fastener Notice .
  3. Install the EGR valve bolts.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  4. Install the EGR pipe to the EGR valve.
  5. Install the EGR pipe.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    6. Fig 2: Identifying Evaporative Emission (EVAP) Canister Purge Solenoid Valve
    GM1544746Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector (1) to the EGR valve (2).
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  8. Position the transaxle filler tube to the normal installed position and install the filler tube to transaxle case fasteners.

    Tighten:  Tighten the fasteners to 130 N.m (115 lb in).

  9. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals