Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.5L >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Oil Pressure Switch
    GM82225Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the engine oil pressure switch.

    Tighten:  Tighten the switch to 16 N.m (12 lb ft).

  2. Install the electrical connector to the engine oil pressure switch.
  3. Connect the battery negative cable to the battery. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
scientia non olet · About Mike's Workshop Manuals