Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Stationary Window System >> Repair Instructions >> Quarter Window Replacement (Without A20 Manual) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Quarter Window Components
    GM1232910Courtesy of GENERAL MOTORS CORP.
  1. Install the bushings.
  2. Install the retainers.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bodyside window latch hinge screw to the window.

    Tighten:  Tighten the screw (2) to 1.6 N.m (1.4 lb in).

  4. Install the bodyside window in the opening.
  5. Install the bodyside window hinge nuts (2) to the body.

    Tighten:  Tighten the nuts (2) to 3.5 N.m (1.6 lb in).

  6. Use J 34946  or equivalent in order to install the latch hinge pin. See Special Tools .
  7. Install the bodyside window latch hinge pin (4) to the latch (3).
  8. Inspect the bodyside window for proper operation.
  9. Close the bodyside window.
  10. Install the body side rear upper garnish molding. Refer to Trim Panel Replacement - Body Lock Pillar Upper in Interior Trim.
  11. Install the bodyside window garnish molding. Refer to Finish Panel Replacement - Upper Rear Trim in Interior Trim.
  12. Remove the masking tape from around the perimeter of the painted surfaces and inner trim of the window.
scientia non olet · About Mike's Workshop Manuals