Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Stationary Window System >> Repair Instructions >> Quarter Window Replacement (With A20 Power) >> Removal Procedure

Removal Procedure

    Fig 1: Locating Quarter Window Components
    GM1232904Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before removing a stationary window, apply a layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.
  1. Remove the body side rear upper finish panel. Refer to Trim Panel Replacement - Body Lock Pillar Upper in Interior Trim.
  2. Remove the rear corner upper finish panel. Refer to Finish Panel Replacement - Upper Rear Trim in Interior Trim.
  3. Open the bodyside window to the full open position.
  4. Disconnect the electrical connector (4) from the power window actuator (5).
  5. Disconnect the actuator arm from the rear window hinge.
  6. Remove the bodyside window hinge nuts (2).
  7. Remove the bodyside window (1) from the opening.
  8. Inspect the quarter window weatherstrip. Replace the weatherstrip, if damaged. Refer to Weatherstrip Replacement - Rear Quarter Window in Body Rear End.
  9. Remove the hinge screw (3) from the window (1).
scientia non olet · About Mike's Workshop Manuals