Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Window Replacement - Sliding Door Swing Out >> Removal Procedure

Removal Procedure

    IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the sliding door garnish molding. Refer to Garnish Molding Replacement - Sliding Door in Interior Trim.
    3. Fig 1: Locating Plugs For Swing-Out Window Access Hole
    GM320044Courtesy of GENERAL MOTORS CORP.
  3. Use a small flat-bladed tool in order to remove the plugs from the swing-out window access hole on the sliding door.
    4. Fig 2: Locating Swing-Out Window Latch Screws
    GM320051Courtesy of GENERAL MOTORS CORP.
  4. Remove the swing-out window latch screws.
  5. Remove the stud nuts from the swing-out window hinge.
    6. Fig 3: View Of Swing-Out Window
    GM320047Courtesy of GENERAL MOTORS CORP.
  6. Remove the swing-out window from the sliding door.
scientia non olet · About Mike's Workshop Manuals