Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Lock Replacement - Sliding Door Rear >> Removal Procedure

Removal Procedure

    IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the sliding door inner trim panel. Refer to Trim Panel Replacement - Side Rear Door .
  3. Remove the sliding door water deflector. Refer to Water Deflector Replacement - Sliding Door .
  4. Remove the sliding door latch screws.
  5. When the sliding door rear lock is loose, unhook the lock rod from the sliding door rear lock.
  6. Disconnect the detent switch electrical connector.
    7. Fig 1: Removing/Installing Sliding Door Rear Lock
    GM1480602Courtesy of GENERAL MOTORS CORP.
  7. Remove the sliding door rear lock from inside the sliding door.
scientia non olet · About Mike's Workshop Manuals