Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (7.0L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the generator on the mounting bracket.
    NOTE: Refer to Fastener Notice .
  2. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

    3. Fig 1: Engine Wiring Harness Generator Lead Nut & Generator Electrical Connector
    GM651874Courtesy of GENERAL MOTORS CORP.
  3. Connect the generator electrical connector (1 and 2).
  4. Install the battery feed cable.
  5. Install the battery feed terminal nut (3).

    Tighten:  Tighten the battery feed cable nut to 13 N.m (10 lb ft).

    CAUTION: Refer to Battery Disconnect Caution .
    Fig 2: Connecting The Negative Battery Cable
    GM1672575Courtesy of GENERAL MOTORS CORP.
  6. Install the drive belt. Refer to Drive Belt Replacement - Accessory .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (7.0L)  or Battery Negative Cable Disconnect/Connect Procedure (6.0L) .
scientia non olet · About Mike's Workshop Manuals