Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Power Roof System) >> Repair Instructions >> Folding Top Locating Pin Receiver Position Sensor Switch Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Folding Top
    GM1507225Courtesy of GENERAL MOTORS CORP.
  1. Open the folding top as shown in the illustration.
  2. Place a protective covering over the interior of the vehicle and the adjacent body panels.
    Fig 2: Removing The Locating Pin Screws
    GM1509118Courtesy of GENERAL MOTORS CORP.
  3. Using a grease pencil, mark the location of the sensor.
  4. Remove the locating pin screws.
  5. Note the location and the amount of any shims that may be present.
scientia non olet · About Mike's Workshop Manuals