Electronic Suspension Control Module Replacement

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electronic Suspension Control Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle . Remove the right front wheel rear liner. Refer to Front Wheelhouse Liner Replacement (Front Liner) or Front Wheelhouse Liner Replacement (Rear Liner) .
1	Electronic Suspension Control (ESC) Module Tip: Disconnect the electrical connector. Release the 2 locking tabs on the bottom of the bracket and raise the ESC upward to release the upper arms to remove. Reprogram the ESC module. Refer to Control Module References .

Callout

Component Name

Preliminary Procedures

Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
Remove the right front wheel rear liner. Refer to Front Wheelhouse Liner Replacement (Front Liner) or Front Wheelhouse Liner Replacement (Rear Liner) .

Electronic Suspension Control (ESC) Module
Tip:

Disconnect the electrical connector.
Release the 2 locking tabs on the bottom of the bracket and raise the ESC upward to release the upper arms to remove.
Reprogram the ESC module. Refer to Control Module References .