Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> SSR Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0110 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 5:  Tests the ability of the EBCM to control the pump motor. If the test lamp illuminates, the pump motor circuit within the EBCM is good.
DTC C0110

Step Action Yes No
Schematic Reference: Antilock Brake System Schematics 
Connector End View Reference: Antilock Brake System Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Use the scan tool in order to clear the DTCs.
  2. Cycle the ignition to the OFF position.
  3. Start the engine.
  4. In park or neutral, release the brake.
  5. Turn OFF the engine.
Does the DTC reset?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3
  1. Remove the electronic brake control module (EBCM) from the brake pressure modulator valve (BPMV). Refer to Electronic Brake Control Module Replacement .
  2. Inspect the EBCM to BPMV connector for conditions which could cause an intermittent, such as damage, corrosion, poor terminal contact, or presence of brake fluid.
Is the connector OK and the cavity free of brake fluid?		 Go to Step 5  Go to Step 4 
4
  1. If connector corrosion or damage is evident, replace the BPMV and/or EBCM as necessary.
  2. If brake fluid is present, replace both the BPMV and EBCM. Refer to Brake Pressure Modulator Valve Replacement  and Electronic Brake Control Module Replacement .
Did you complete the repair?		 Go to Step 8  -
5 
  1. Connect the EBCM harness to the EBCM with the BPMV still separated.
  2. Connect a test lamp between the pump motor circuits, internal EBCM side, using the J 35616  GM Terminal Test Kit. See Special Tools .
  3. Cycle the ignition to the OFF position.
  4. Start the engine.
  5. In park or neutral, release the brake.
Does the test lamp illuminate?		 Go to Step 7  Go to Step 6 
6 Replace the EBCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the repair?		 Go to Step 8  -
7 Replace the BPMV. Refer to Brake Pressure Modulator Valve Replacement .
Did you complete the repair?		 Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About Mike's Workshop Manuals