Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Malibu LS, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

NOTE: Refer to FASTENER NOTICE .
Fig 1: Removing & Installing Ignition Control Module
GM896789Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Make sure the interconnect is lined up and the interconnect seal is in place before installing the attachment screws.
  1. Install the EI module and the attachment screws.

    Tighten:  Tighten the EI module screws to 1.5 N.m (13 lb in).

  2. Connect the module harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
  3. Refer to CONTROL MODULE REFERENCES for programming and setup information.
scientia non olet · About Mike's Workshop Manuals