Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System - 3.5L - DTC P0010 To DTC P0420) >> DTC P0010 or P0011 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Measure the resistance of the CMP actuator solenoid. Resistance should be between 4.8-5.2 ohms.
  2. Point the CMP actuator towards a shop towel. Connect a jumper wire between the CMP actuator low reference circuit at the solenoid and ground. Connect a fused jumper wire to the CMP actuator high control circuit at the solenoid. Momentarily touch the fused jumper to battery voltage. The CMP actuator solenoid pintle should immediately extend.
scientia non olet · About Mike's Workshop Manuals