Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Impala SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Installation Procedure

Installation Procedure

CAUTION: Refer to GASOLINE/GASOLINE VAPORS CAUTION in Cautions and Notices.
CAUTION: Refer to FUEL GAGE LEAK CAUTION in Cautions and Notices.
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  2. Remove the fuel rail pressure fitting cap.
  3. Connect the J 34730-1A  to the fuel pressure valve. Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
  4. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
scientia non olet · About Mike's Workshop Manuals