Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Spark Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Gap the spark plug, using round wire type spark plug gap gage.

    Gap:  Adjust the spark plug gap to 1.14 mm (0.045 in).

    2. Fig 1: View Of Spark Plugs
    GM465982Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT coat the spark plugs with anti seize compound. Over torquing could occur and damage to the cylinder head threads may result.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the spark plugs with a spark plug socket.

    Tighten:  Tighten the spark plugs to 20 N.m (15 lb ft).

  3. Install the ignition coil housing. Refer to Ignition Coil Housing Replacement .
scientia non olet · About Mike's Workshop Manuals