Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Throttle Body
    GM782280Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the new MAP sensor seal provided with the new MAP sensor.
  1. Install the MAP sensor (2) into the intake manifold.
  2. Connect the MAP sensor harness connector.
  3. Install the throttle body. Refer to Throttle Body Assembly Replacement .
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About Mike's Workshop Manuals