Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
    2. Fig 1: View Of Fuel Pump Module And Fuel Tank Pressure Sensor Electrical Connectors
    GM889969Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the fuel pump module harness electrical connector from the fuel tank pressure sensor.
    3. Fig 2: View Of Fuel Tank Pressure Sensor
    GM889971Courtesy of GENERAL MOTORS CORP.
  3. Position 2 flat-bladed screwdrivers, one on each side of the sensor, near the vacuum port.
  4. Carefully use the screwdrivers to lift and release the sensor from the fuel pump module.
scientia non olet · About Mike's Workshop Manuals