Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Fuel Rail Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  2. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  3. Use a back up wrench on the fuel rail and disconnect the fuel supply pipe.
  4. Disconnect the fuel injector harness connectors.
    5. Fig 1: View Of Fuel Rail
    GM854296Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel rail attaching studs.
    6. IMPORTANT: Use care when removing the fuel rail assembly in order to prevent damage to the fuel injectors electrical connector terminals and spray tips.
  6. Remove the fuel rail using the following procedure:
    1. Pull the fuel rail back and upward to remove the fuel injectors from the cylinder head ports.
    2. Rotate the fuel rail in order to position the injectors downward.
    3. Remove the fuel rail.
  7. Remove the fuel injectors. Refer to Fuel Injector Replacement .
scientia non olet · About Mike's Workshop Manuals