Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the connector position assurance (CPA) from the accelerator pedal position (APP) sensor connector.
  2. Disconnect the APP sensor harness connector.
  3. Remove the APP assembly attachment bolts from the brake pedal assembly.
    4. Fig 2: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  4. Remove the APP assembly from the vehicle.
scientia non olet · About Mike's Workshop Manuals