Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Controls - 2.0L - (Introduction)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body & Gasket
    GM1339289Courtesy of GENERAL MOTORS CORP.
  1. Inspect the throttle body gasket and replace if necessary.
  2. Install the throttle body to the supercharger.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body attaching bolts.

    Tighten:  Tighten the throttle body attaching bolts to 10 N.m (89 lb in).

  4. Connect the throttle body control harness connector.
  5. Connect the EVAP purge line.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About Mike's Workshop Manuals