Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Controls - 2.0L - (Introduction)) >> Repair Instructions >> Temperature Manifold Absolute Pressure (TMAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating TMAP Sensor
    GM1382191Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the new TMAP sensor seal provided with the new TMAP sensor.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the TMAP sensor into the intake manifold.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the TMAP sensor harness connector.
scientia non olet · About Mike's Workshop Manuals