Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Controls - 2.0L - (Introduction)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF Sensor
    GM1386444Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF sensor into the air cleaner housing.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 2 N.m (18 lb in).

  3. Connect the MAF sensor electrical connector.
  4. Install the left front splash shield-engine. Refer to Splash Shield Replacement - Engine in Body Front End.
  5. Install the left front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals