Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> HHR LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - 2.2L - (Introduction)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Throttle Body
    GM898518Courtesy of GENERAL MOTORS CORP.
  1. Inspect the throttle body gasket (3) and replace if necessary.
  2. Install the throttle body (4) to the intake manifold.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body attaching bolts (1).

    Tighten:  Tighten the throttle body attaching bolts to 10 N.m (89 lb in).

  4. Connect the vacuum hoses to the throttle body.
    5. Fig 2: View Of Idle Air Control (IAC) Valve & Throttle Position (TP) Sensor
    GM783168Courtesy of GENERAL MOTORS CORP.
  5. Connect the TP sensor harness connector (2).
  6. Connect the IAC valve harness connector (1).
  7. Install the air cleaner resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  8. Test the accelerator movement by depressing the pedal to the floor and releasing the pedal.
scientia non olet · About Mike's Workshop Manuals