Circuit/System Testing
- Ignition OFF, disconnect the harness connector of the appropriate HO2S.
- Ignition ON, verify that the HO2S parameter is between 350-500 mV.
- If less than 350 mV, test the signal circuit of the HO2S sensor for a short to ground. If the circuit/connections test normal, replace the ECM.
- Verify that none of the following conditions exist:
- Rich fuel injectors-Refer to Fuel Injector Balance Test with Special Tool .
- Water intrusion in the HO2S harness connector
- High fuel system pressure-Refer to Fuel System Diagnosis .
- Fuel that is contaminated-Refer to Alcohol/Contaminants-in-Fuel Diagnosis (w/o Special Tool) or Alcohol/Contaminants-in-Fuel Diagnosis (w/Special tool) .
- Fuel saturation of the evaporative emissions (EVAP) canister
- Restricted exhaust
- Contaminated HO2S - Silicon
- If you find any of the above conditions, repair as necessary.
- If all circuits/connections test normal, replace the applicable HO2S.