Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Brake & Hub Assembly (2WD)

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Brake Dust Caution .

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Remove the brake rotor (2) shown on the 1500 Series. Refer to Front Brake Rotor Replacement .

Fig 2: View Of Wheel Speed Sensor Cable And Connectors

Courtesy of GENERAL MOTORS CORP.

Remove the wheel speed sensor (WSS) cable mounting clip from the knuckle.
Remove the WSS cable mounting clip from the upper control arm.
Remove the WSS cable mounting clip from the frame attachment point.
Remove the WSS cable electrical connector.

Fig 3: View Of Wheel Speed Sensor Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the WSS mounting bolt.

Fig 4: Exploded View Of Disc Brake Components (2WD)

Courtesy of GENERAL MOTORS CORP.

NOTE: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.

Remove the wheel speed sensor (5) from the hub/bearing assembly (4) shown on the 2500/3500 Series.