Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Cutaway 6.6 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 937 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Brake Pressure Modulator Valve Pre-Charge Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Fluid Outlet Pipe
    GM1372859Courtesy of GENERAL MOTORS CORP.
  1. Install the PCP (2) into the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the PCP front and side mounting bracket bolts (1, 3).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Connect the engine wiring harness to the PCP bracket.
  4. Connect the PCP electrical connector (4) to the vehicle connector harness.
  5. Remove the cap or plug from the outlet pipe and install the outlet pipe to the PCP (5).

    Tighten:  Tighten the brake fluid outlet pipe nut to 25 N.m (18 lb ft).

    6. Fig 2: Identifying Master Cylinder Components
    GM1372862Courtesy of GENERAL MOTORS CORP.
  6. Install the inlet hose (4) and clamp (3) to the PCP (2).
  7. Remove the crimping tool from the inlet hose.
  8. Install the inner fender splash shield.
  9. Install the left front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  11. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
  12. Using a scan tool, perform a PCP bleed procedure. Refer to Antilock Brake System Automated Bleed Procedure (W/JL4)  or Antilock Brake System Automated Bleed Procedure (w/o JL4) .
scientia non olet · About Mike's Workshop Manuals