Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Cobalt SS, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Intake >> Installation Procedure

Installation Procedure

    IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
    2. Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the CMP sensor.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Electrical Connector
    GM1647999Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake CMP sensor electrical connector (2).
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About Mike's Workshop Manuals