Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2006 >> Chevy Express G2500, Van Cargo Extended, 6.6 2 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 6.6L (LLY) - DTC P0016 To DTC P0342 >> DTC P0128 >> Circuit/System Testing

Circuit/System Testing

  1. Turn OFF the ignition and all electrical accessories. Allow sufficient time for the control module to power down before taking a resistance measurement.
  2. Disconnect the ECT sensor.
  3. Measure for a proper value of less than 5 ohms of resistance between the ECT low reference circuit and a good ground.
    • If the resistance is more than 5 ohms, test the low reference circuit for a high resistance.
    • If the ECT low reference circuit tests normal, replace the ECM.
  4. Disconnect the ECM.
  5. Measure for a proper value of less than 5 ohms of resistance on the ECT sensor signal circuit.
    • If the resistance is more than 5 ohms, repair the high resistance in the ECT signal circuit.
  6. Remove and test the ECT sensor.
    • If the resistance measurements of the ECT sensor are out of range, replace the sensor.
    • If the ECT sensor tests normal and the DTC continues to set, replace the ECM.
scientia non olet · About Mike's Workshop Manuals