Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 432 (Electronic Suspension System - Automatic Level Control) >> Repair Instructions >> Automatic Level Control Relay Replacement (VIN U) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector For Inflation Timer Relay
    G01828518Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the inflation timer relay.
    NOTE: Refer to FASTENER NOTICE .
    2. Fig 2: Inflator Control Panel
    G01828519Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts/screws to the inflator relay.

    Tighten 

    Tighten the inflator relay bolts/screws to 2 N.m (18 lb in).

  3. Install the inflator control panel retainers.
  4. Install the inflator air valve opening cover by pushing the lever outboard.
  5. Install the ELC/TRAILER fuse.
scientia non olet · About Mike's Workshop Manuals