Test Description

The numbers below refer to the step numbers on the diagnostic table.

2: Use the scan tool to check the normal state of the Traction Off indicator control.
3: This step ensures that the instrument cluster can operate the Traction Off indicator.

Traction Off Indicator Always On

Step	Action	Yes	No
Schematic Reference: ABS Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Traction Control System (TCS) Warning Lamp parameter in the TCS data list. Does the scan tool display OFF?	Go to Step 3	Go to Step 4
3	Turn OFF the ignition. Turn ON the ignition, with the engine OFF. Observe the Traction Off indicator ON the instrument panel cluster (IPC) during the bulb check. Does the Traction Off indicator illuminate during the bulb check and then turn OFF?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 5
4	Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 6
5	Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 7
6	Replace the EBCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair?	Go to Step 8	-
7	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the repair?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2