Entering On-Board Diagnostics

The OBD modes can only be entered in a sequential order from modes 1-3.

• Enter the right PSD system OBDs using the right B-pillar open/close switch and the right ON/OFF switch in the overhead console.
• Enter the left PSD system OBDs using the left B-pillar open/close switch and the left ON/OFF switch in the overhead console.
  1. Both PSDs must be closed and in the latched position.
  2. Place the ignition switch in the OFF position.
  3. Place the ON/OFF switch in the overhead console to the OFF position.
  4. Press and hold the B-pillar PSD open/close switch.
  5. While holding the open/close switch, operate the ON/OFF switch through 10 ON and OFF cycles within 10 seconds stopping in the ON position.
  6. The sliding door alarm will sound one long tone indicating diagnostic mode 1 is active.