Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing 4 Insulator Bolts That Attach BPMV To Bracket
    GM1235535Courtesy of GENERAL MOTORS CORP.
  1. Install the bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 insulator bolts.

    Tighten:  Tighten the bolts to 10 N.m (86 lb in).

    3. Fig 2: Removing 3 Nuts That Attaching Electronic Brake Control Module (EBCM)/brake Pressure Modulator Valve (BPMV)
    GM1234790Courtesy of GENERAL MOTORS CORP.
  3. Install the 3 nuts that attach the bracket to the left front wheelhouse.

    Tighten:  Tighten the nuts to 10 N.m (86 lb in).

  4. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals