Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing MAF Sensor From Air Cleaner Cover
    GM1236094Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the MAF sensor to the air cleaner cover.

    Tighten:  Tighten the screws to 0.6 N.m (5 lb in).

  2. Connect the MAF sensor electrical connector.
  3. Start and idle the engine.
  4. Inspect the air intake duct for leaks.
scientia non olet · About Mike's Workshop Manuals