Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transaxle - Introduction & Repair Instructions) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
  1. Inspect the O-ring (11). If damaged, replace as necessary.
    2. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the vehicle speed sensor (10) and the retaining bolt (9).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  3. Connect the electrical connector to the sensor.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals