Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Uplander Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1) in Engine Electrical.
  2. Remove the coolant reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  3. Remove the left front sheet metal diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal - Left orBrace Replacement - Front Fender Upper Diagonal - Right in Body Front End.
  4. Remove the air cleaner side cover and the air cleaner element. Refer to Air Cleaner Element Replacement .
    5. Fig 1: View Of Air Cleaner Upper Cover
    GM1404634Courtesy of GENERAL MOTORS CORP.
  5. Remove the air cleaner upper cover bolts and the air cleaner upper cover.
  6. Remove and reposition the powertrain control module (PCM) with the wiring harness.
    7. Fig 2: Locating Air Cleaner Bolts
    GM1404635Courtesy of GENERAL MOTORS CORP.
  7. Remove the air cleaner bolts and the air cleaner.
scientia non olet · About Mike's Workshop Manuals